Glaze material · Fluxes, feldspars & frits
Ferro frit 3134
Also sold as: frit 3134
A calcium-sodium borosilicate frit with essentially no alumina — the standard low-temperature boron flux.
In published recipes
Used in 1,907 of 10,859 glaze recipes (18%)
Typical amount when present
20% of the dry batch — half of recipes fall between 12.5% and 26%.
Fired surface of those recipes
Glossy 69% · Semi-glossy 14% · Satin 9% · Matte 8%
Most often mixed with
Materials that appear in the same recipes most often.
What potters should know
Frits are man-made fluxes that melt between about 760 and 930 °C; because the oxides are pre-melted they are insoluble and stable in the bucket. See Ferro's data sheet for the exact analysis.
Handling and safety
Dry ceramic materials generate respirable silica dust. Use a NIOSH-approved N95 or P100 respirator and adequate ventilation when mixing dry, and wet-clean surfaces.
This information is provided for planning purposes and is derived from publicly available sources including OSHA regulations, NIOSH guidance, and manufacturer safety data sheets. It does not constitute professional safety advice. Consult your material suppliers' SDS documents and applicable local regulations for authoritative safety guidance.
Questions
- How much Ferro frit 3134 do potters use in a glaze?
- Across 1,907 published glaze recipes containing it, the typical amount is 20% of the dry batch, with half of recipes between 12.5% and 26%. Colorants and additives sit far lower than fluxes and glass formers; treat these as a range to test around, not a target.
- What cone is Ferro frit 3134 used at?
- It appears in recipes across the range; the most common cones among published recipes are cone 6, cone 5, cone 7. Where a material sits depends on the rest of the recipe more than on the material itself.
- Is Ferro frit 3134 safe to use?
- It carries no specific hazard flag beyond the general rule for all dry ceramic materials: avoid breathing the dust and read the supplier's SDS.
Related materials
| Glaze material | recipes | typical |
|---|---|---|
| Ferro frit 3124 | 675 | 30% |
| Ferro frit 3110 | 408 | 30.2% |
| Gerstley borate | 1,926 | 14.5% |
Sources. Usage figures are computed by Claybench over 10,859 glaze recipes compiled from publicly shared community recipe collections (snapshot 2026-02-27) — counts only; no recipe is reproduced, and the figures describe that collection, not every recipe in existence. Material roles and notes are paraphrased from Linda Arbuckle's Ceramic Materials handout unless noted. Hazard notes summarise supplier SDS guidance; read the SDS for the product you buy.
Claybench tracks your glaze materials, not just recipes
Inventory, hazard flags, and per-piece material cost — the same reference behind this page, wired into your studio.