How much Ilmenite do potters use in a glaze?

Across 52 published glaze recipes containing it, the typical amount is 2% of the dry batch, with half of recipes between 2% and 4.2%. Colorants and additives sit far lower than fluxes and glass formers; treat these as a range to test around, not a target.

What cone is Ilmenite used at?

It appears in recipes across the range; the most common cones among published recipes are cone 10, cone 6, cone 9. Where a material sits depends on the rest of the recipe more than on the material itself.

Is Ilmenite safe to use?

It carries no specific hazard flag beyond the general rule for all dry ceramic materials: avoid breathing the dust and read the supplier's SDS.

← All materials

Glaze material · Colorants

Ilmenite

Also sold as: granular ilmenite

Iron titanate — like rutile with much more iron; in granular form it speckles.

colorantopacifierContributes: Fe₂O₃ · TiO₂

In published recipes

Used in 52 of 10,859 glaze recipes (0.5%)

Typical amount when present

2% of the dry batch — half of recipes fall between 2% and 4.2%.

Fired surface of those recipes

Glossy 38% · Matte 38% · Semi-glossy 14% · Semi-matte 10%

Cones where it appears

Share of recipes containing this material that fire to each cone.

Most often mixed with

Materials that appear in the same recipes most often.

Silica79%Whiting58%Rutile52%EPK48%Zinc oxide44%Dolomite44%Gerstley borate33%Ball clay25%

Chemistry

Raw formula: FeO·TiO₂
Fired formula: same as raw

From Linda Arbuckle's materials table. Mineral formulas are idealized; buy an analysis for the bag you have. Equivalent weight is the weight that supplies one molecule of the fired oxide — the number glaze calculation uses.

What potters should know

Roughly half titanium and half iron oxide, against rutile's 90/10.

Handling and safety

Dry ceramic materials generate respirable silica dust. Use a NIOSH-approved N95 or P100 respirator and adequate ventilation when mixing dry, and wet-clean surfaces.

This information is provided for planning purposes and is derived from publicly available sources including OSHA regulations, NIOSH guidance, and manufacturer safety data sheets. It does not constitute professional safety advice. Consult your material suppliers' SDS documents and applicable local regulations for authoritative safety guidance.

Questions

How much Ilmenite do potters use in a glaze?: Across 52 published glaze recipes containing it, the typical amount is 2% of the dry batch, with half of recipes between 2% and 4.2%. Colorants and additives sit far lower than fluxes and glass formers; treat these as a range to test around, not a target.
What cone is Ilmenite used at?: It appears in recipes across the range; the most common cones among published recipes are cone 10, cone 6, cone 9. Where a material sits depends on the rest of the recipe more than on the material itself.
Is Ilmenite safe to use?: It carries no specific hazard flag beyond the general rule for all dry ceramic materials: avoid breathing the dust and read the supplier's SDS.

Related materials

Glaze material	recipes	typical
Rutile	1,518	4%

Sources. Usage figures are computed by Claybench over 10,859 glaze recipes compiled from publicly shared community recipe collections (snapshot 2026-02-27) — counts only; no recipe is reproduced, and the figures describe that collection, not every recipe in existence. Material roles and notes are paraphrased from Linda Arbuckle's Ceramic Materials handout unless noted. Hazard notes summarise supplier SDS guidance; read the SDS for the product you buy.

Claybench tracks your glaze materials, not just recipes

Inventory, hazard flags, and per-piece material cost — the same reference behind this page, wired into your studio.

Start free